I am setting up a system with Crashmail/JamNNTPD to run under Linux. All went well, I can toss messages into the system, but when I
try to scan for messages to export I get the following error message:
^ 16-Dec-16 14:10:09 Scanning all areas for messages to export
! 16-Dec-16 14:10:09 Failed to read message #231 in JAM messagebase "/home/flbessa/fido/echo/BR_BBSING"
Any ideas? I can see the messages over JAMNNTPD.
You don't mention which distroy and the bitness... BUT...
That is exactly the issue I had... on Kubuntu 14.04.5 *64b*
CM II is/was written with only a - > *32b* < - world in mind..
Thanks a lot! It worked:
NOSECURITY TOSS CrashMail II 1.5 started successfully! Packets will be
Tossing 0a5fb121.pkt (1K) from 4:801/188.0 (17-???-16 11:13:54) / pw,
Although there were an issue with the date (here it's
DD-MM-AA, I don't know how to fix it), it went out well.
Scan is also fine.
Thanks again!
NOSECURITY TOSS CrashMail II 1.5 started successfully! Packets
will be
What distro and bitness is this?? I see CM II 1.5, so I am guessing instead that you chose to move to a 32b distro versus the older 0.71 version?
Tossing 0a5fb121.pkt (1K) from 4:801/188.0 (17-???-16 11:13:54) /
pw,
Although there were an issue with the date (here it's
DD-MM-AA, I don't know how to fix it), it went out well.
Smart Aleck humor ON
Can't fix that, as your date is wrong. :p ;) :) ;) ;)
Smart Aleck humor OFF
Scan is also fine.
Thanks again!
Glad its working, but if you could provide what you did ...
Distro? Release and version?
Change distro bitness?
Or something else?
I ask since your using the CM II 1.5 version, and I would like to add
to the KB for others in the future...
Even playing with some things on that CM II 1.5 version which should resolve this, on 64b systems, it still doesn't there is still a sneak
64 v.32b issue in there some where.
I am running Ubuntu 16.04 64-bit release. I downloaded the ZIP package from eljaco.se as you suggested and am using it here. :)
I just downloaded the package from the URL you suggested... Is there a specific command that will show the correct version?
I just downloaded the package from the URL you suggested... Is there a specific command that will show the correct version?
| Sysop: | Winzlo |
|---|---|
| Location: | Minnesota, USA |
| Users: | 11 |
| Nodes: | 16 (0 / 16) |
| Uptime: | 495944:25:41 |
| Calls: | 82 |
| Files: | 1,070 |
| D/L today: |
27 files (11,920K bytes) |
| Messages: | 287,036 |